Item as describedFast shippingGood communication 5 star sellerHighly recommended. ALL HARNESSING AND CONNECTIONS NEEDED ARE SUPPLIED IN THIS KIT. PRODUCT DOES NOT APPLY TO VEHICLES TRIMMED WITH FACTORY NAVIGATION SYSTEM.
Drill hole utilizing provided holesaw. Be sure to pre-inspect area prior to drilling for proper clearance and safe mounting. Feed camera wires thru hole and follow path of original harnessing making your way to the factory screen location. Power and ground for camera. Power and ground for camera can be located and utilized from the rear tail light assembly. At the reverse light, locate the BROWN wire and connect red camera 12 volt wire. Locate a clean, paint free metal chassis spot and connect camera ground wire. Tap on an extra wire from the brown reverse wire at the taillight, long enough to run along with the camera video wire. This will be needed to connect to the screen as well as the video rca for picture. Run cables (both extra power wire and video rca) from camera to the rear of the screen in the dash.Be sure to avoid any pinch points or potential areas that can damage the camera wires. Connect the extra power wire from the taillight to the power wire coming off of the provided screen harness (this will tell the monitor when to show camera everytime the vehicle is in reverse). Connect the video rca to the provided harness rca input. This will provide the video signal to the screen provided that power, ground and video for the camera have been connected properly.
Make sure u have sufficient battery power before testing. Camera should activate and display on original screen while in reverse. NOTE: Camera system is not compatible with navigation equipped models. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Video\Rear View Monitors/Cams & Kits".
The seller is "wayne81473" and is located in this country: US. This item can be shipped worldwide.