Brand New High Quality Full Set HD Waterproof Backup Parking Reversing Rear View Camera For Toyota Tacoma. 1 Exactly fitted Rear View Camera. Necessary Wiring Cable(Vedio&Power Cable). Special design to replace the original car license plate light, perfect match, no damage to the installation. Low light perfect night vision.Can help avoid accidents, durability is good. 100% brand new, same as pictures above.
Switching power supply Low power circuit design, small heat, stable work. Each of our products need to pass the vibration test, aging treatment, waterproof test, high and low temperature test UV test, air tightness test and a series of vehicle standard test. Horizontal Resolution: 420 TV lines. Effective pixels: 628 X 582 pixels. Minimum illumination: 3Lux/ F1.2 (0 Lux with IR on).
Diagonal Viewing Angle: 135 degree. Signal to noise ratio: >48db.
Video Output: RCA interface, 1.0Vp-p, 75Ohm. Operating Temperature: -10 to 50 degree centigrade, RH95% Max. Storage Temperature: -30 to 60 degree centigrade, RH95% Max. Take out your stock license plate light at the back of your car.
Fix the camera to where the stock license plate light was. Connect the built-in license plate light of the camera to where the stock license plate light was connected to get the power. Connect the power of the camera to your car reverse lights - red wire to positive and black wire to negative.
Connect the video cable of the camera to the extension cord. Connect the extension cord to your car monitor. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Video\Rear View Monitors/Cams & Kits". The seller is "aphonecase" and is located in this country: CN. This item can be shipped worldwide.